Skip to main content

Aircraft Maintenance manuals have a full menu and are bookmarked and indexed.

 

Most manuals are bookmarked and Indexed. We can set up a download for you on any manual, just ask.

Fisher Potter 25 Motor Sailor for sale Fairways Marine in Florida

boat

$12,000.00
Write a Review
SKU:
FP25
Availability:
available now
Minimum Purchase:
1 unit
Maximum Purchase:
5 units
Shipping:
Calculated at Checkout
Adding to cart… The item has been added

Rare Fairways Marine Fisher Potter 25 Motor sailor for sale near Dayton Beach, Fl. Makes a great day sailor. Has A replacement Yanmar 3gm30 27 hp diesel with less than 40 hours on it. In 2019 All filters changed. Tank cleaned. New keyed ign switch installed. New impeller, new bilge pump. New fuel lines. This is a closed cooling system (antifreeze). NEW DRIPLESS Lasdrop shaft Seal. Autopilot coupled was coupled to a Garmin GPSMAP531S chart/plotter. New Lexan skylight in forward cabin. Great sails in bags. Ketch rigged. Manuals and paperwork. Hydraulic steering system coupled. New HAWKEYE digital sounder w/ backup transducer installed. Although is looks small, the cabin and below deck have 5' ceiling height in center. V berths below forward deck. Lots of storage space. Hold below main deck in front of pilot house has a mahogany center walkway but otherwise is empty. Hide away sink in pilot house. I've seen some with the optional berths installed in this large area but this was built without them. . Very unique heavy built boat not often seen in the usa. Built in England in 1976. 1 of approximately 255 ever built. Runs perfectly, pumps good water, 2 1000 amp marine batteries will need replacing. Several anchors and some spare props included. I have the rear mizzen mast and sail too.  Also, would make a great fishing boat with the large hold it has.

Potter 25: seen as a full member of the Fisher family: a Fisher 25 without the raised main cabin resulting in a larger work deck directly in front of the wheelhouse. Sail are mostly new and in sail bags.

It's time for polishing, and bottom painting and other minor updates and repairs. Sail Rigging needs work. Some rub rail work is needed, it's a ongoing project that I don't have time or ability to finish.

Located Edgewater, fl. If you're thinking of shipping it very expensive. $7 to $15K depending on your coast.
Dimensions
LOA: 25 ft 3 in
Beam: 9 ft 5 in
LWL: 21 ft 0 in
Minimum Draft: 3 ft 9 in
Maximum Draft: 3 ft 11 in
Displacement: 10080 lbs
Ballast: 5000 lbs
Engine(s): New in 2008 Yanmar 3 cyl 27hp diesel w 40 hours.
Cruising Speed: 5 knots
Tankage
Fuel: (40) Water: Fiberglass (20)
Sails
Furling genoa
Rigging
Steering wheel
Inside Equipment
Manual bilge pump
Electric bilge pump
Construction
White heavy-duty GRP hull with a full-length keel, Encapsulated cast iron ballast. Varnished teak rubbing strake, bulwarks and capping. Keel/transom hung rudder with wheel steering and emergency tiller.

White GRP deck and wheelhouse.